Operation - Atag WU9054TMM Notice D'utilisation

USE

Operation

EN 10
Buttons must be pressed and held. This is to prevent functions from
being accidentally switched on or off.
Pairing the remote
This remote control must be paired to the cooker hood before first use.
• Start up the appliance (power on). Press and hold the -'and '+ for
3 seconds. The hood will start 'pairing mode' for 5 minutes.
• Activate the 'Remote pairing mode' by holding 'c' and 'w' for 3 sec.
• During pairing all the indicators on the hood and remote will blink. All
indicators will turn off when the connection is established.
If the connection is not established repeat the entire pairing process.
Remote control will go into standby after 30 seconds. The remote will
wake up when it is picked up or detects movement.
Switching extraction on and off
• Press and hold the 'Fan' key on the remote for 1 second.
The cooker hood will switch on at the lowest setting.
• Press the '+' key again for a higher fan setting. Press and hold the '+'
key for 1 second to select the highest setting (boost).
• Press the '-' key to select a lower setting.
The extraction setting is indicated by the speed level indicators on the hood.
• To switch off the cooker hood, press and hold the 'Fan' key for 1 second.