Dolmar PS-3410 TH Manuel D'emploi Et De Sécurité page 19

A
4
B
C
6
D
8
PS-3410 TH
PUTTING INTO OPERATION
CAUTION:
Before doing any work on the guide bar or chain, always
switch off the engine and pull the plug cap off the spark
plug (see „Replacing the spark plug"). Always wear pro-
tective gloves!
CAUTION:
Do not start the saw until it has been completely assembled
and inspected!
Mounting the guide bar and saw chain
Use the universal wrench delivered with the chain saw for the
following work.
Put the chain saw on a stable surface and carry out the following
1
steps for mounting the guide bar and chain:
Disengage the chain brake by pulling the hand guard (1) in the
direction of the arrow.
2
Unscrew retaining nuts (2).
Carefully spread the sprocket guard (3), pull it from its fixture
(4) and remove it.
3
Turn the chain adjusting screw (5) to the left (counterclockwise)
until the pin (6) is at the left stop.
5
Position the guide bar (7). Make sure that the pin (8) of the chain
tightener is in the hole on the guide bar.
7
19