Using Your Air Conditioner; Selecting The Mode; Adjusting The Temperature - Whirlpool WHAP101AW Guide D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

USING YOUR AIR CONDITIONER

Appearance may vary.
Turning the Air Conditoner ON or OFF
Press POWER to turn the air conditoner ON or OFF.
IMPORTANT:
If you turn off the air conditioner, wait at least 3
minutes before turning it back on. This prevents the
air conditioner from blowing a fuse or tripping a circuit
breaker.
Do not try to operate your air conditioner in the Cool mode
when outside temperature is below 65°F (18°C). The inside
evaporator coil will freeze up, and the air conditioner will not
operate properly.
NOTE: In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.
Display
During normal operation, display will show the
current room temperature. When the TEMP/TIME t
and s buttons are pressed, the unit will display the
set temperature or delay time.

Selecting the Mode

The Mode button has three settings:
Cool (COOL)
Dehumidify (DEHUM)
Fan (FAN)
Press the MODE button until the indicator light for the desired
setting is lit.
Cooling (COOL) Mode
In cooling mode, the air conditioner cools air from the room and
vents hot air to the outdoors through the vent hose. Adjust fan
speed and the temperature setting to fit your desired comfort
level. Temperature setting range is 61°F–90°F (16°C–32°C).
IMPORTANT: The vent hose must exhaust to the outdoors when
using cool mode.
Dehumidify (DEHUM) Mode
Air is dehumidified as it passes through the unit, without being
in full cooling mode. For temperatueres above 77°F (25°C), the
fan speed is adjustable. If the termperature is 77°F (25°C) or
below, the fan speed is set automatically to LOW and cannot be
adjusted.
IMPORTANT: For best results, the continuous drain hose should
be connected and the vent hose should not be exhausted to the
outside, allowing the warm air to recirculate into the room.
8
Fan (FAN) Mode
In this mode, only the fan will run. Air is circulated through the
room with no cooling.
NOTE: The air conditioner does not need to be vented to the
outdoors in Fan mode.
Selecting the Fan Speed
The Fan Speed has 3 settings:
LOW
MED
HIGH
Press the SPEED button until the indicator light for
the desired setting is lit.

Adjusting the Temperature

Press the TEMP/TIME s and t buttons to adjust the set
temperature up or down in 1° increments.
Temperature setting range is 61°F–90°F
(16°C–32°C). After 15 seconds, the display will
return to the current room temperature.
NOTE: Temperature may only be adjusted in
Cooling Mode.
When in TIMER mode, pressing the TEMP/TIME s and t
buttons will adjust the delay time for the air condtioner to shut off
or turn on.
Switching between Fahrenheit and Celsius:
Press both s and t buttons at the same time to toggle the
displayed units between °F and °C.

Publicité

Table des Matières
loading

Table des Matières