Table des Matières
Publicité
Wall assembly
21, 28 or 45 mm thick tongue and groove logs
Versatile design possible due to subsequent installation of windows and doors
Door
Solid door with cylinder lock incl. 3 keys
Glass insert in 3 mm clear glass or 4 mm single-pane safety glass
Window
Window with compact frame
Roof
19 mm thick roof boards nailed to study roof purlins, roof covering in bitumen roof paper or bitumen shingles.
3.2. Name and address of the manufacturer
Manufacturer:
weka Holzbau GmbH
Johannestr. 16
D-17034 Neubrandenburg
Tel.
Fax
E-mail info@weka-Holzbau.com
4. Product description
4.1. General functions and area of application
The cabins are intended exclusively for the storage of garden equipment etc. or as a place to relax for a short
while and enjoy your garden. You are not permitted to use the cabin as a residence or heated accommodation.
4.2. Dimensions
You can find the dimensions on the views included in the pack.
4.3. Safety information
Selection of the substrate
The ground under the cabin should be level, horizontal and built up. If your cabin is located near slopes and
basements, you should consult a local builder. Otherwise, there may be a risk of collapse.
Built-up ground must be compressed to ensure that the cabin does not sink, otherwise damage may occur. Any
turf must also be removed.
Space requirements
The space required depends on the size of your cabin. The cabin must always be accessible from the outside on
all sides to allow for inspection, ventilation and protection against weathering. The space required should be
approximately 1.0 – 1.5 m larger than your cabin on all sides.
Safety information and warnings
In order to prevent accidents, we recommend that children be kept out of the direct vicinity during assembly.
During assembly, children under the age of 14 should be kept at least 3 m from the assembly site.
The current occupational safety and accident prevention regulations are to be observed. Information can be
obtained from a builder.
The roof is only to be accessed on load-distributing boards.
When you are working on a roof, avoid the risk of falling by complying with the current accident prevention
regulations (e.g. scaffolding requirements, safety rails).
Agree the required measures and operating conditions with a local builder or competent work safety authority.
Always work with helpers!
When unpacking the loose wooden parts and when assembling the cabin, we recommend that you wear safety
boots and work gloves. When using a drill or saw, you should also wear protective goggles.
The roof is to be cleared of high snow loads (in excess of 0.75 kN/m² or approx. 30 cm in height).
Techn. Änderungen vorbehalten!
: (0049)-395 429080
: (0049)-395 4290883
Alle Maßangaben sind ca. Maße.
11
Copyright HRB 3662
Publicité
Chapitres
Table des Matières
