Table des Matières
Publicité
38
41
43
45a
14
2193025-12.indd 14
39
40
42
44
45b
English
Cleaning the hose and nozzle
The vacuum cleaner stops automatically if the nozzle,
tube, hose or filters and s-bag® becomes blocked. In such
cases, disconnect from mains and allow to cool for 20-30
minutes. Clear blockage and/or replace filters and s-bag®
and restart.
Tubes and hoses
38
Use a cleaning strip or similar to clear the tubes
and hose.
39
Hose handle could be dismantled from hose if
cleaning is needed.
40
It may also be possible to remove the obstruction
in the hose by squeezing it. However, be careful in
case the obstruction is caused by glass or needles
caught inside the hose.
Note: The warranty does not cover any damage to the hose
caused by cleaning it.
Cleaning the floor nozzle
41
Be sure to frequently clean the combination floor
nozzle.
42* Press each wheel-hub and draw away the wheels.
Remove dust-balls, hair or other objects that may
be entangled.
43* Larger objects can be accessed by removing the
connection tube from the nozzle.
Cleaning the turbo nozzle*
44
Disconnect the nozzle from the vacuum cleaner
tube and remove entangled threads, etc. by snip-
ping them away with scissors. Use the hose handle
to clean the nozzle.
45a Disconnect the nozzle from the vacuum cleaner
tube and remove entangled threads, etc. by snip-
ping them away with scissors. Use the hose handle
to clean the nozzle.
45b In case the turbo nozzle stops working, open the
cleaning lid and remove any objects that obstructs
the turbine to rotate freely.
* Certain models only.
2/25/09 2:37 PM
Publicité
Table des Matières
