How To Remove The Battery Pack - Kokido Manga X Manuel D'utilisation

 Never smoke or allow a spark or flame in the vicinity of the battery or the robot.
 Do not expose the battery to fire or intense heat as this may result in an explosion.
CAUTION!
If a battery leak occurs, avoid any contact with the leaking fluids and place the damaged
battery in a plastic bag.
If leaking fluids come in contact with skin and clothing, wash immediately with plenty
-
of soap and water.
If leaking fluids come in contact with eyes, do not rub eyes, immediately flush eyes
-
with cool running water for at least 15 minutes and do not rub them. Seek medical
attention as soon as possible.
How to remove the battery pack (To be done by authorized technician)
Recommended tools (not included): Screwdriver.
1. Follow section "EMPTYING THE DEBRIS COMPARTMENT" to release the
top cover (preassembled with the swivel head). Place the cover upside down and
release the swivel head by turning its bottom locking plate anticlockwise. Remove
the swivel smoothing-ring.
2. Use the screwdriver to unscrew the 4 screws located at the bottom of the head
to release the bottom plate first. Then unscrew all the screws at the base as
shown. Remove the impeller and pry open the base to expose head inside.
3. Remove out the battery pack to expose the PCBA. To detach the battery
connection wire, press on the clip of the connector to pull it out. NOTE: Wrap the
connector immediately with insulating tape in order to avoid any short circuit
caused by the contact of both wire terminals.
17