Building In - Zanussi ZQS 6124 Mode D'emploi

Building-in
Dimensions of the recess
DO013
The dimensions of the recessed installation area
must correspond with those indicated in the figure.
1xB
1xA
1
1. Installation kit
2. Two cabinet securing brackets
with the installation pack. They need to be
assembled onto the cabinet prior to cabinet being
pushed into the Kitchen aperture.
Left hand
bracket
2
- To fit these brackets remove the two screws at the
top left and right hand front corners of the cabinet.
- Position the two brackets as shown in the figure
and replace the two securing screws.
3. Push the appliance into place. The plug socket
2xC
1xK
18xI
(D) are supplied
4. The joint cover (B) is to be assembled after having
Right hand
bracket
+
-
- +
max. 890 mm
3
necessary for connection of the appliance to the
electricity supply should be positioned, so that the
plug is not placed in the recess.
To adjust the height proceed as follows:
- Loosen or tighten the two front feet.
- The rear feet are adjusted by turning the screw in
the front kick plate to the left or right.
1
4
installed the appliance in the recess.
55