Machine Setup; Explanation Of Warning Symbols And Notes; Basic Safety Instructions; Package Contents - Hama MINI S6 Mode D'emploi

G Operating Instructions

Machine setup

1. Device head
2. Extendable arm
3. Paper intake shaft
4. Warning symbols
5. Slider switch
6. "I" position (forwards)
7. "O" position (off)
8. "<<" position (backwards)
9. Connecting cable (back of the device)
1. Introduction
1.1 Foreword
Thank you for choosing a Hama product.
Take your time and read the following instructions and information completely. Please keep
these instructions in a safe place for future reference. If you sell the device, please pass
these operating instructions on to the new owner.
Note – Importance of the operating instructions
Failure to observe the operating instructions when using the product constitutes
incorrect use or wilful misuse and is not permitted.
Note
This device is a new, unused product.
Any cutting residue present may have been left over from quality assurance tests during
production.

1.2 Explanation of warning symbols and notes

Risk of electric shock
This symbol indicates a risk of electric shock from touching product parts carrying
hazardous voltage.
Warning
This symbol is used to indicate safety instructions or to draw your attention to speci c
hazards and risks.
Note
This symbol is used to indicate additional information or important notes.

1.3 Package contents

• "Mini S6" Shredder
• These operating instructions
2. Safety

2.1 Correct use

• The product is intended for private, non-commercial use only.
• Use the product only for the intended purpose.
• The product is intended only for use inside buildings.
• Protect the product from dirt, moisture and overheating and use it in dry rooms only.
• Do not use the product in the immediate vicinity of heaters, other heat sources or in
direct sunlight.
• Do not use the product in a damp environment and avoid splashing water.
• Do not operate the product outside the power limits speci ed in the technical data.
• Do not operate the product continuously, as it is not designed for this.
• Do not use the product in areas in which electronic products are not permitted.
• Do not drop the product and do not expose it to any major shocks.
• This product is not intended for use by persons, including children, with limited physical,
sensory or mental abilities or lacking in experience or knowledge, unless they are
supervised by a person responsible for their safety or have been instructed on how to
use the product.
• As with all electrical products, this device should be kept out of the reach of children.
• Keep the packaging material out of the reach of children due to the risk of suffocation.
• Dispose of packaging material immediately in accordance with the locally applicable
regulations.
• Do not modify the product in any way. Doing so voids the warranty.
2
• Only use the article under moderate climatic conditions.
• Always pull directly on the plug when disconnecting the cable, never on the cable itself.
Note
The product is only intended for volumes generated by households.
Note
The device head (1) can be placed on round and angular paper baskets with diameters /
widths from approx. 28 - 34 cm
The following materials may and may NOT be shredded:
Paper
Paper with staples
Magnetic strip and ID chip cards
CDs, DVDs, Blu-Rays
Continuous paper, sticky labels, slides, newspaper, cardboard, paper clips,
laminate, plastic (with the exception of the objects stated earlier)

2.2 Basic safety instructions

Please note the following safety instructions in order to use the device safely.
• Check the device before use for any visible external damage. Do not put a damaged
device into operation.
• People who, as a result of their physical, mental or motor capacities, are unable to
operate the device safely must only use the device under supervision or after instruction
by a responsible person.
• Faulty components must only be replaced with original spare parts. Only these parts are
guaranteed to meet the required safety standards.
• Protect the device against moisture and the penetration of liquids or objects. In the
event of contact with liquid, disconnect the device from the power supply immediately.
Warning - risk of cutting on the cutting rollers
Do not touch the cutting rollers.
Risk of electric shock
• Do not open the device or continue to operate it if it becomes damaged.
• Do not use the product if the AC adapter, adapter cable or power cable is damaged.
• Do not attempt to service or repair the product yourself. Leave any and all service
work to quali ed experts.
2.3 Explanation of symbols used on the product label
Warning - risk of injury
Note the warning symbols in order to avoid injuries or damage to the device.
✓
✓
✗
✗
✗