Futurelight PHS-575 Mode D'emploi page 43

If the projector shall be lowered from the ceiling or high joists, professional trussing systems have to be
used. The projector must never be fixed swinging freely in the room.
Caution: Projectors may cause severe injuries when crashing down! If you have doubts concerning the
safety of a possible installation, do NOT install the projector!
Before rigging make sure that the installation area can hold a minimum point load of 10 times the projector's
weight.
When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.
Follow the instructions mentioned at the bottom of the base.
the structure (truss) to which you are attaching the fixtures is secure.
Please note: for overhead rigging in public or industrial areas, a series of safety instructions have to be
followed that this manual can only give in part. The operator must therefore inform himself on the current
safety instructions and consider them.
The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety
precautions!
Install the safety bond by inserting the quick link in the hole on the bottom of the base. Pull the safety bond
over the trussing system etc. Insert the end in the quick link and tighten the fixation screw.
The maximum drop distance must never exceed 20 cm.
A safety bond which already hold the strain of a crash or which is defective must not be used again.
Before taking into operation for the first time, the installation has to be approved by an expert!
DANGER OF FIRE!
Use 2 appropriate clamps to rig the fixture on the truss.
Make sure that the device is fixed properly! Ensure that
DANGER TO LIFE!
CAUTION!
The Moving-Head can be placed directly on the
stage floor or rigged in any orientation on a truss
without altering its operation characteristics (see
the drawing).
The fixture's base enables to be mounted in two
ways.
For overhead use (mounting height >100 cm),
always install an appropriate safety bond.
You must only use safety bonds complying with
DIN 56927, quick links complying with DIN 56927,
shackles complying with DIN EN 1677-1 and BGV
C1 carbines. The safety bonds, quick links,
shackles and the carbines must be sufficiently
dimensioned and used correctly in accordance with
the latest industrial safety regulations (e. g. BGV
C1, BGI 810-3).
43/117 00024314.DOC, Version 1.5