Troubleshooting - Husqvarna 445 II Manuel D'utilisation

Masquer les pouces Voir aussi pour 445 II:

Manuel d'utilisation (124 pages)

Manuel de l'opérateur (112 pages)

Manuel d'utilisation (100 pages)

Table des Matières

Les langues disponibles

the saw chain if there are cracks on the cutters. (Fig.

138)

To do a check of the guide bar

1. Make sure that the oil channel is not blocked. Clean

if it is necessary. (Fig. 139)

2. Examine if there are burrs on the edges of the guide

bar. Remove the burrs using a file. (Fig. 140)

3. Clean the groove in the guide bar. (Fig. 141)

4. Examine the groove in the guide bar for wear.

Replace the guide bar if it is necessary. (Fig. 142)

5. Examine if the guide bar tip is rough or very worn.

(Fig. 143)

6. Make sure that the bar tip sprocket turns freely and

that the lubricating hole in the bar tip sprocket is not

blocked. Clean and lubricate if it is necessary. (Fig.

144)

7. Turn the guide bar daily to extend its life cycle. (Fig.

145)

To do maintenance on the fuel tank

and the chain oil tank

•

Drain and clean the fuel tank and the chain oil tank

regularly.

•

Replace the fuel filter yearly or more frequently if

necessary.

The engine does not start

Product part to examine

Starter pawls

Fuel tank

1286 - 003 - 30.06.2020

Air cleaning system

AirInjection

removes dust and dirt before the particles are caught by

the air filter. AirInjection

and the engine.

(Fig. 146)

To clean the cooling system

The cooling system keeps the engine temperature

down. The cooling system includes the air intake on the

starter and the air guide plate, the pawls on the flywheel,

the cooling fins on the cylinder, the cooling channel and

the cylinder cover.

1. Clean the cooling system with a brush weekly or

2. Make sure that the cooling system is not dirty or