Accessories - Triton TW SMPJ Instructions D'utilisation Et Consignes De Sécurité

Introduction
Thank you for purchasing this Triton product. This manual contains
information necessary for safe and effective operation of this
product. This product has unique features and, even if you are
familiar with similar products, it is necessary to read this manual
carefully to ensure you fully understand the instructions. Ensure all
users of the product read and fully understand this manual.
Intended Use
Mini pocket-hole jig for repeated use in joinery work. Can be used
for panel fixing, corners and mitre joints.
Before Use
WARNING: Always adhere to all safety advice and instructions
for any power tool used in conjunction with this product.
Operation
WARNING: NEVER hold the jig by hand when drilling; it must
be clamped securely to the workpiece and a suitable workbench.
Failure to do so could damage the tool and/or cause serious
personal injury.
Note: Generally, set the jig then set the drill depth. Ideally, the drill
tip should emerge close to the middle of the material being drilled.
1. Determine the thickness of the material to be drilled and position
the jig accordingly, then check the drilling angle (Fig. I–III)
Note: For thinner material (Fig. I) move the jig forward and for
thicker material (Fig. III) move the jig back.
2. Lock the drill-depth collar (Fig. IV) onto the drill bit at the required
drill depth
3. Using a pencil, mark a line at the front position of the jig (Fig. V)
4. Clamp the jig to the timber and workbench using the pencilled
mark, and drill at high speed (Fig. VI) with the depth-set drill
Note: If the clamp does not have a large enough capacity, use an
additional clamp (Fig. VII).
5. For additional pocket-holes, move the jig along the pencil line,
then clamp and drill (Fig. VIII)
6. After drilling all the holes, the piece is ready for the pocket-hole
screws (Fig. IX) and plugs. See the table below for recommended
screw size.
GB
4
Original Instructions
Timber Thickness
13 – 18mm / ½" –
19 – 25mm / ¾" – 1"
26 – 30mm / 1" – 1
31 – 37mm / 1
≥38mm / ≥1
Note: For hard wood use a fine thread, and for soft wood use a
coarse thread.
Tips
• When assembling a joint, use a backing board (Fig. X)
• The pocket-hole jig can be used for drawer construction or
repairs (Fig. XI)
• The pocket-hole jig can be used for framing and mitre joints (Fig.
XII)
• The pocket-hole jig can be used for joining panels (Fig. XIII)
• The end stop assists in quick-clamping the jig to the edge of a
workpiece; slide the tab off, invert, then slide back on to the jig
(Fig. XIV)

Accessories

• A full range of accessories including jigs, plugs, screws and bits
is available from your Triton stockist
Maintenance
Contact
For technical or repair service advice, please contact the helpline on
(+44) 1935 382 222
Web: tritontools.com/en-GB/Support
Address:
Powerbox
Boundary Way
Lufton Trading Estate
Yeovil, Somerset
BA22 8HZ, United Kingdom
Screw
⁄ " 25mm / 1"
11
16
30mm / 1
⁄ " 35mm / 1
1
4
⁄ " – 1 ⁄ " 50mm / 2"
1 7
4 16
⁄ " 60mm / 2
1
2
⁄ "
1
4
⁄ "
1
2
⁄ "
1
2