Cleaning And Maintenance; Cleaning Agents; Removing And Installing The Filter - Bosch DWK0 5G 0 Série Notice D'utilisation

2Cleaning and maintenance

:
Warning – Risk of burns!
C l e a n i n g a n d m a i n t e n a n c e
The appliance becomes hot during operation. Allow the
appliance to cool down before cleaning.
:
Warning – Risk of electric shock!
Penetrating moisture may result in an electric shock.
Clean the appliance using a damp cloth only. Before
cleaning, pull out the mains plug or switch off the circuit
breaker in the fuse box.
:
Warning – Risk of electric shock!
Do not use any high-pressure cleaners or steam
cleaners, which can result in an electric shock.
:
Warning – Risk of injury!
Components inside the appliance may have sharp
edges. Wear protective gloves.

Cleaning agents

To ensure that the different surfaces are not damaged
by using the wrong cleaning agent, observe the
information in the table. Do not use any of the following:
Harsh or abrasive cleaning agents,
■
Cleaning agents with a high alcohol content,
■
Hard scouring pads or cleaning sponges,
■
High-pressure cleaners or steam cleaners.
■
Wash new sponge cloths thoroughly before use.
Follow all instructions and warnings included with the
cleaning agents.
Area Cleaning agent
Stainless steel Hot soapy water:
Clean with a dish cloth and then dry with a
soft cloth.
Clean stainless steel surfaces in the grind
direction only.
Special stainless steel cleaning products are
available from our after-sales service or from
specialist retailers. Apply a very thin layer of
the cleaning product with a soft cloth.
Painted surfaces Hot soapy water:
Clean using a damp dish cloth and dry with a
soft cloth/towel.
Do not use any stainless steel cleaners.
Aluminium and plastic Glass cleaner:
Clean with a soft cloth.
Cleaning and maintenance
Area Cleaning agent
Glass Glass cleaner:
Clean with a soft cloth. Do not use a glass
scraper.
Controls Hot soapy water:
Clean using a damp dish cloth and dry with a
soft cloth/towel.
Risk of electric shock caused by penetrating
moisture.
Risk of damage to the electronics from pene-
trating moisture. Never clean operating con-
trols with a wet cloth.
Do not use any stainless steel cleaners.

Removing and installing the filter

The filter must be serviced regularly in order to
guarantee efficient filtration of odours and grease.
Metal grease filter
The metal grease filters must be cleaned every
150 operating hours or at least every three months.
:
Warning – Risk of fire!
Fatty deposits in the grease filter may catch fire.
Clean the grease filter at least every 3 months.
Never operate the appliance without a grease filter.
Activated charcoal filter (only in circulating-air mode)
The activated charcoal filters must be changed at least
every 3 to 5 months.
Removing metal grease filter
The metal grease filters filter the grease out of kitchen
steam. To keep them in good working order, the filters
should be cleaned at least every 3 months.
Open the lock on the metal grease filters and
1.
remove the filters from the retainer.
Notes
– When you do this, take hold of the metal grease
filters from underneath with your other hand.Make
sure that the metal grease filters do not fall and
damage the hob.
– Fat may accumulate in the bottom of the metal
grease filters. Hold the filters level to prevent fat
from dripping out.
Clean the metal grease filters.
2.
Clean the inside of the appliance.
3.
en
7