Tecno-gaz ONYX B 5.0 Mode D'emploi page 83

Reading of the T2 probe during sterilization
A 653
above the maximum limit
A 661 Error in the probe reading
A 662 Error in the probe reading
Error for failed pressure achievement
A 701
during the first two phases of the warm-up
Error for failed pressure achievement
A 711
during the third phase of the warm-up
Reading of the T1 probe during sterilization
A 751
below the minumum limit
Reading of the T2 probe during sterilization
A 753
below the minumum limit
Temperature of the 121°C cycle out o the
A 781
maximum limit
Temperature of the 134°C cycle out o the
A 782
maximum limit
Errors of out of maximum time during the
A 801
first phases of discharge
Errors of out of maximum time during the
A 811
last phase of discharge
Cycle interrupted due to power supply
A 901
failure
It's need to make a SD CARD periodic backup.
In the event of one of the alarms persisting after some time, consult technical assistance.
• Let cool the room
• Reset and restart the system
• Reset and restart the system
• Reset and restart the system
• Reset and restart the system
• Reset and restart the system
• Reset and restart the system
• Reset and restart the system
• Let cool the room
• Reset and restart the system
• Let cool the room
• Reset and restart the system
• Clean the filter in the room
• Reset and restart the system
• Clean the filter in the room
• Reset and restart the system
• Check the power supply
system of the machine and of
the room.
• Reset and restart the system
ENGLISH
39