Format/Initialization; Select Speed Scale - CAMPAGNOLO ErgoBrain Manuel D'instructions

Format/Initialization

When you use the ErgoBrain for the first time, or af-
ter you have replaced the battery, you need to format
the unit. Before doing this, find out your front wheel's
circumference.
Note: From the second time, formatting can be sim-
plified. A press of AC button will retain the former data such as the
wheel circumference and information on chainring/sprocket, so just
press SET button in each process of formatting. Only for the setting
of chainring shift timing, you need to press S/S button.
1. Press AC button.
Note: While holding down SET button, press and release AC button. All display
goes on for one second and then it changes to the scale selection screen.
Then release SET button. With this operation all the data are erased and the
unit is initialized (EEPROM returns to its default state). Perform this operation
only when you need to reset the odometer to zero. By initialization, all the
former data such as the wheel circumference and information on chainring/
sprocket is erased and returns to the default state.
1
To the next step

2. Select speed scale.

Push MODE button to switch between [KMH] and [MPH]. Push SET
button to decide.
2
To the next step
AC
Format
All displays illuminate (1 sec.)
Switch between [KMH] and [MPH].
MODE
SET
SET AC
Initialization of
EEPROM
(See the "Note" above)
UK
L
- 4