Battery Charging - Horizon Hobby Night Vapor Ultra Micro Série Manuel D'utilisation

6

Battery Charging

See the Battery Warning and Guidelines section and familiarize yourself thoroughly with it before continuing.
Follow these steps to charge the Li-Po battery with the included charger.
1. Remove the cover on the bottom of the charger and install four of the included AA batteries, noting
proper polarity. Replace the cover after the AA batteries are installed.
2. Slide the battery into the slot on the charger. The end cap of the battery is specifically designed to
allow the battery to be slid into the slot easily one way (usually with the label on the battery facing
outward) to prevent reverse polarity connection. However, check for proper alignment and polarity
before proceeding to the next step.
3. Gently press the battery and its connector into the charge jack/connector located at the bottom of the
slot in the charger.
4. When you make the connection successfully, the LED light on the charger turns solid red, indicating
charging has begun.
5. Charging a fully discharged (not over-discharged) 70mAh battery takes approximately 30–40 minutes.
As the battery nears full charge, the LED begins to blink. When the battery is fully charged, the LED
light blinks approximately every 20 seconds or goes out entirely.
Note: The Li-Po battery included with your Night Vapor arrives partially charged, so the initial charge
may only take 15–20 minutes.
Note: You can expect to charge the Li-Po flight battery 10–15 times before needing to replace the AA
batteries in the charger. Replacing the included batteries with alkaline batteries results in more
charge cycles.
Note: If the LED remains on for longer than 40 minutes while charging and/or 5 seconds after
removing the Li-Po fight battery, replace the AA batteries in the charger.
CAUTION: Only use a charger specifically designed to charge a Li-Po battery. Failure to do so
could result in fire causing injury or property damage.
CAUTION: Never exceed the recommended charge rate.