Insignia NS-DVDVCR Guide De L'utilisateur page 4

If you mount your DVD/VCR,
follow the manufacturer's
instructions and use a
mounting accessory
recommended by the
manufacturer. Move a
DVD/VCR and cart
combination with care. Quick stops,
excessive force, and uneven surfaces may
cause your DVD/VCR and cart combination
to overturn.
• Ventilation–Slots and openings in the
cabinet and the back or bottom are provided
for ventilation, to ensure reliable operation of
your DVD/VCR and to protect it from
overheating. Do not block openings. Do not
place your DVD/VCR on a bed, sofa, rug, or
other similar surface. Your DVD/VCR should
never be placed near or over a radiator or
heat register. Do not place your DVD/VCR in
a built-in installation such as a bookcase or
rack unless correct ventilation is provided or
the manufacturer's instructions have been
adhered to.
• Power sources–Use only the type of power
source indicated on the marking label. If you
are not sure of the type of power supply to
your home, consult your DVD/VCR dealer or
local power company. For DVD/VCRs
intended to operate from battery power, or
other sources, refer to the operating
instructions.
• Grounding or polarization–Your DVD/VCR
is equipped with a polarized
alternating-current line plug (a plug having
one blade wider than the other). This plug will
fit into the power outlet only one way. This is
a safety feature. If you are unable to insert
the plug fully into the outlet, try reversing the
plug. If the plug should still fail to fit, contact
your electrician to replace your obsolete
outlet. Do not defeat the safety purpose of
the polarized plug.
• Power-cord protection–Route power-supply
cords so that they are not likely to be walked
on or pinched by items placed upon or
against them, paying particular attention to
cords at plugs, convenience receptacles, and
the point where they exit from your
DVD/VCR.
• Overloading–Do not overload wall outlets
and extension cords because this can result
in a risk of fire or electric shock.
• Object and liquid entry–Never push objects
of any kind into your DVD/VCR through
openings because they may touch dangerous
voltage points or short out parts that could
result in a fire or electric shock. Never spill
liquid of any kind on your DVD/VCR.
• Servicing–Do not attempt to service your
DVD/VCR yourself because opening or
removing covers may expose you to
dangerous voltage or other hazards. Refer all
servicing to qualified service personnel.
• Damage requiring service–Unplug your
DVD/VCR from the wall outlet and refer
servicing to qualified service personnel under
the following conditions:
• When the power supply cord or plug is
damaged or frayed.
4
•
•
•
•
•
• Replacement Parts–When replacement
parts are required, make sure that the
service technician uses replacement parts
specified by the manufacturer that have the
same characteristics as the original part.
Unauthorized substitutions may result in fire,
electric shock, injury to persons, or other
hazards.
• Safety Check–Upon completion of any
service or repairs to your DVD/VCR, ask the
service technician to perform routine safety
checks to determine that your DVD/VCR is in
correct operating condition.
• Heat–Place your DVD/VCR away from heat
sources such as radiators, heat registers,
stoves, or other products (including
amplifiers) that produce heat.
www.insignia-products.com
If liquid has been spilled, or objects have
fallen into your DVD/VCR.
If your DVD/VCR has been exposed to
rain or water.
If your DVD/VCR does not operate
normally by following the operating
instructions. Adjust only those controls
that are covered by the operating
instructions, because incorrect
adjustment of other controls may result in
damage and often requires extensive
work by a qualified technician to restore
your DVD/VCR to its normal operation.
If your DVD/VCR has been dropped or
damaged in any way.
When your DVD/VCR exhibits a distinct
change in performance, this indicates a
need for service.
Note
This reminder is provided to call the CATV system
installer's attention to Article 820-40 of the NEC
that provides guidelines for correct grounding and,
in particular, specifies that the cable ground
should be connected to the grounding system of
the building as close to the point of cable entry as
practical.
Note
Batteries should never be thrown away or
incinerated but disposed of in accordance with
your local regulations concerning chemical
wastes.
Caution
To prevent electric shock, match the wide blade of
plug to the wide slot in the power outlet and fully
insert the plug.