Specifications; Legal Notices - Insignia NS-DVDVCR Guide De L'utilisateur

Cleaning discs
Fingerprints and dust on the disc can cause
poor picture quality and sound distortion. Before
playing, clean the disc with a clean cloth. Wipe
the disc from the center out.
Do not use strong solvents such as alcohol,
benzine, thinner, commercially available
cleaners, or anti-static spray intended for older
vinyl records.
Note
Never operate this product immediately after
moving it from a cold location to a warm location.
Leave it for two or three hours without operating it.
If you use this product in such a situation, it may
damage tapes, discs, or internal parts.
Resetting the DVD/VCR
Reset your DVD/VCR if you observe any of the
following symptoms:
• When the DVD/VCR is plugged in, but the
power will not turn on or off.
• When the display window does not work.
• When the DVD/VCR does not operate
normally.
To reset the DVD/VCR:
• Press and hold the POWER button for more
than five seconds. This forces the DVD/VCR
to turn off. Press the POWER button again to
turn the DVD/VCR back on.
- OR -
Unplug the power cord and then plug the
power cord again after more than five
seconds.

Specifications

General
Power requirements
Power consumption
Dimensions (approx.)
(w × h × d)
Mass (approx.)
Operating temperature 41°F to 104°F
Operating humidity
Signal system
VCR Specifications
Head system
Timer
Tape speed
Tape width
AC 120V, 60 Hz
16W
16.9 × 3.1 × 10.2 in.
(430 × 79 × 260 mm)
8.8 lbs (4 kg)
(5°C to 40°C)
5% to 90%
NTSC
Four head helical
scan azimuth system
12-hour display type
with AM, PM
SP: 33.35 mm/sec
LP: 16.67 mm/sec
SLP: 11.12 mm/sec
12.7 mm
www.insignia-products.com
Rewind time
Frequency range
Signal-to-noise ratio
Dynamic range
Channel separation
DVD specifications
Laser system
Frequency response
Signal-to-noise ratio
Harmonic distortion
Dynamic range
Inputs
VIDEO IN (LINE1,2)
AUDIO IN (LINE1,2)
Outputs
VIDEO OUT
S-VIDEO OUT
COMPONENT VID. OUT (Y) 1.0 V (p-p),
(PROGRESSIVE SCAN) (Pb)/(Pr) 0.7 V (p-p),
Audio output (digital)
Audio output (analog)
Accessories:
Video cable (1)
Audio cable (L, R)(1)
Remote Control (1)
Batteries (2)
Design and specifications are subject to change without
notice.

Legal notices

FCC compliance statement
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference when the
product is operated in a residential
installation.This equipment generates, uses, and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
About 3 min. (T-120)
20 Hz to 20 kHz
> 43 dB
> 88 dB
> 60 dB
Semiconductor laser,
wavelength 650 nm
DVD (PCM 96 kHz):
8 Hz to 44 kHz,
DVD (PCM 48 kHz):
8 Hz to 20 kHz
CD: 8 Hz to 20 kHz
> 100 dB (Analog out)
< 0.008%
> 95 dB (DVD/CD)
1.0 Vp-p 75 ohms, sync
negative, RCA jack × 2
-6 dBm more than
47 ohms, RCA jack
(L, R) × 2
1 Vp-p 75 ohms, sync
neg., RCA jack × 1
(Y) 1.0 V (p-p),
75 ohms, neg. sync,
Mini DIN 4-pin × 1
(C) 0.286 V (p-p)
75 ohms
75 ohms, neg. sync,
RCA jack × 1
75 ohms, RCA jack × 2
0.5 V (p-p), 75 ohms,
RCA jack × 1
1.1 Vrms (1 kHz,
-6 dB), 600 ohms,
RCA jack (L, R) × 2
21