Meanings Of Symbols - HIKOKI CG 31EBS Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 28
English

MEANINGS OF SYMBOLS

NOTE: Some units do not carry them.
Symbols
WARNING
The following show symbols used for the machine. Be sure that you understand their meaning before use.
Grass Trimmer / Brush Cutter
It is important that you read, fully understand
and observe the following safety precautions
and warnings. Careless or improper use of the
unit may cause serious or fatal injury.
Read, understand and follow all warnings and
instructions in this manual and on the unit.
Always wear eye, head and ear protectors when
using this unit.
Keep all children, bystandards and helpers
15 m away from the unit. If anyone approaches
you, stop the engine and cutting attachment
immediately.
Be careful of thrown objects.
Shows maximum shaft speed. Do not use the
cutting attachment whose max rpm is below the
min
-1
shaft rpm.
Gloves should be worn when necessary, e.g.,
when assembling cutting equipment.
Use anti-slip and sturdy footwear.
Start control lever
On/Start
START
Off /Stop
/
STOP
Fuel and oil mixture
Idle speed adjustment
Priming pump
Guaranteed sound power level
(Original instructions)
Idle
P
L
pA, eq
ISO22868
L
WA, Ra(M)
2000/14/EC
L
WA, Ra(G)
2000/14/EC
a
hv, eq(F)
6
Blade thrust may occur when the spinning
blade contacts a solid object in the critical area.
A dangerous reaction may occur causing the
entire unit and operator to be thrust violently.
This reaction is called blade thrust. As a result,
the operator may lose control of the unit which
may cause serious or fatal injury. Blade thrust is
more likely to occur in areas where it is diffi cult
to see the material to be cut.
Hot Surface – Contact with hot surface can
cause serious burns.
Indicate handle location. Do not attach handle
above this point.
Displacement
Spark plug
Idling speed
Speed of output shaft
Max. engine output
Fuel tank capacity
Dry weight (without fuel, cutting attachment,
harness and cutting attachment guard)
Cutting attachment
Sound pressure level LpA by ISO 22868
Equivalent*
Measured sound power level LwA by 2000/14/
EC
Racing
Guaranteed sound power level LwA by
2000/14/EC
Racing
Vibration level by ISO 22867
Front or Left handle / Equivalent*

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Cg 31ebspCg 31ebslp

Table des Matières