Installation Of Shield; With Metal Blade - Echo BCLS-520ES Manuel D'utilisation

Before you start

Installation of shield

For shredder blade
For nylon line cutting head

With metal blade

Installing blade
 Wear heavy duty gloves when working with the trimmer blade.
 When replacing the trimmer blade during a trimming task, ensure that the engine is switched off and that the blades
have stopped.
 When turning the product over to replace the trimmer blade, ensure that the fuel tank cap is securely in place.
 Do not attempt to fit the trimmer blade with one hand or without using the socket spanner. Fit the trimmer blade ac-
curately using the supplied socket spanner and tighten firmly in position.
 Do not use any tools other than the provided socket spanner to tighten the blade; a pneumatic or electric tool may
tighten the blade more than necessary and cause the nut or the output shaft to break.
 If worn nut and cup for blade are used, there is a danger of blade getting loose. Replace them with new one.
Failure to do so could lead to an injury or serious accident, or cause a fire.
1. Fit shield (A) to mounting portion of angle transmission and
tighten 4 bolts (B).
 When cutter blade is used, use the shield for metal blade.
2. Fully loosen the bolt (C) on the right side of the bracket (D)
to slide the shield. The bolt itself cannot be removed from the
bracket.
3. Pushing the button (E), slide the shield (F) to the left and re-
move it.
4. Put shield of cutter blade (G) into groove and slide it to the
right until it stops. Be sure to tighten the bolt.
WARNING
10