The Scope And Suggestions For Uses; How To Select Tightening Torque - Hitachi FDS 9DVA Mode D'emploi Et Instructions De Securite

THE SCOPE AND SUGGESTIONS FOR USES

Work
Wood
Drilling Steel
Aluminum
Machine
screw
Screw
tightening Wood
screw

HOW TO SELECT TIGHTENING TORQUE

Cap
position
Approximately 9 in-lbs. (10 kg-cm)
1
Approximately 15 in-lbs. (17 kg-cm)
3
Approximately 23 in-lbs. (26 kg-cm)
7
Approximately 35 in-lbs. (40 kg-cm)
13
Approximately 43 in-lbs. (49 kg-cm)
17
Approximately 52 in-lbs. (60kg-cm)
22
High speed: approximately 52 in-lbs.
Low speed: approximately 156 in-lbs.
NOTE:
The selected content shown in Table 4 indicates the differences according to screw type,
screw size and material used.
CAUTION:
While operating the Cordless driver drill, take care not to lock the motor.
If the motor is locked, immediately turn the power off.
If the motor is locked for a while, the motor or battery will be burnt.
Do not tighten too strongly as the screw heads will be damaged.
Table 3
Cap position
1 – 22
1 –
Table 4
Tightening torque
(60 kg-cm)(FDS9DVA)
approximately 61 in-lbs.
(70 kg-cm)(FDS12DVA)
(180 kg-cm)(FDS9DVA)
approximately 191 in-lbs.
(220 kg-cm)(FDS12DVA)
Suggestions
Use for drilling purpose.
Use the bit and socket matching the screw
diameter.
Use after drilling a pilot hole.
Machine screw
tightening
Screw tightening for
soft wood material
Screw tightening for
hard wood material
Thick screw tightening
When used as a drill.
English
Operation example
17