Hitachi FDS 9DVA Mode D'emploi Et Instructions De Securite page 15

Masquer les pouces Voir aussi pour FDS 9DVA:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3. Check the rotational direction
Triger
switch
marks
R
R
Fig. 6
4. Change rotation speed
Operate the shift knob to change the rotational speed. Move the shift knob in the direction
of the arrow (see Figs. 7 and 8).
When the shift knob is set to "LOW", the drill rotates at a low speed. When set to "HIGH",
the drill rotates at a high speed.
CAUTION:
When changing the rotational speed with the shift knob, confirm that the switch is off.
Changing the speed while the motor is rotating will damage the gears.
When a large force is required for operation (operations indicated in the following chart)
set the shift knob to "LOW". If "HIGH" is set and the unit is used, it may cause the motor
to burn out or malfunction prematurely.
Model
Metal Drilling
Wood Drilling
Wood Screw
Tightening
The bit rotates clockwise (viewed from the rear side) by
pushing the R-side of the selector button.
The L-side of the selector button is pushed to turn the bit
counterclockwise. (See Fig. 6). (The L and
marks
L
provided on the body.)
When the trigger switch is depressed, the tool rotates.
When the trigger is released, the tool stops.
L
The rotational speed of the drill can be controlled by
varying the amount that the trigger switch is pulled.
Speed is low when the trigger switch is pulled slightly and
Selector
increases as the trigger switch is pulled more.
Button
When releasing the trigger of the switch, the brake will be
applied for immediate stopping.
High speed
Shift knob
Fig. 7
FDS 9DVA
When the diameter of the hole
exceeds 3/16"(5mm).
When the diameter of the hole
exceeds 15/32"(12mm).
When the size of the wood
screw exceeds 5/32"(3.8mm)
diameter × 1-1/4"(32mm).
Low speed
Table 2
When the diameter of the hole
exceeds 1/4"(6.5mm).
When the diameter of the hole
exceeds 15/32"(12mm).
When the size of the wood
screw exceeds 5/32"(3.8mm)
diameter × 1-31/32"(50mm).
English
R
marks are
Shift knob
Fig. 8
FDS 12DVA
15

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Fds 12dva

Table des Matières