Assembly Instructions; Before You Begin - IKRA IBRM 1448E TL Manuel D'utilisation

Assembly Instructions

1. Lower handle bar assembly
Attach lower handle bar bolts. Take the weight of the
handle bar and fit the lower bolt first. See fig.1
1
2. Upper handle bar assembly and fit cable clip
Fit the right side flash nut, spring cord guide and bolt. Fit
the left side flash nut and bolt, see fig.2 &3, then fit triple
cable clip to fix cables .see fig.4.
2
4
GB | Operating Instructions
3
3. Attach the grass catcher
Lift the Rear Flap with one hand, lower the grass catcher
hooks onto bar, left & right. See fig.5 & 6.
5
6

Before you begin

Warning! The following proceures must be carried
out before you start the engine of your lawnmower.
1. Fill oil sump with oil
The mower is NOT supplied with oil in the engine, you
have to add 600ml oil before starting the engine for the
first time.
Remove the warning label from the dipstick, remove the
dipstick and slowly pour 600ml oil into the engine via the
oil filler. Replace the dipstick and tighten.
Before you use the mower each time, check the oil level
and if necessary top up with 15W40 / SAE30 engine oil.
To check the oil level, just unscrew the dipstick, wipe
with a rag and replace into the oil filler, but do not screw
it back in place, and remove again. The oil level must
be between the min and max marks on the dipstick.
See Fig. 7~9
8