Specifications - Schumacher Electric 715005061 Manuel D'utilisation

PROBLEM
I cannot select a 6V
or 12V setting.
Green LED is solid
and the display
shows ANALYZING
BATTERY.
Green LED is flashing
and the display shows
CHARGE ABORTED-
BAD BATTERY.
The display shows
CONNECT CLAMPS.

16. SPECIFICATIONS

Input Voltage ................................................................120V AC @ 60Hz, 0.91A
Output Voltage .......................................6V or 12V, with Auto Voltage Detection
Output Current Rating ..........................................................2A @ 6V; 3A @12V
POSSIBLE CAUSE
The charger is equipped
with Auto Voltage Detection,
which automatically detects
the voltage and charges the
battery.
The charger needs to check
the condition of the battery.
The battery is sulfated.
The battery is too large for
the charger.
The clamps are not making a
good connection.
The fuse is bad.
• 14 •
REASON/SOLUTION
No problem; this is normal.
The Green LED will be solid
when the charger is checking
the condition of the battery.
This is normal.
Reset the charger by briefly
unplugging it.
You need a charger with a
higher amp rate.
Check for poor connection at
battery and frame.
Replace the in-line fuse for
the ring connector.
487802781