Alarm Unit - Cobra BRIDGE 4100 Manuel D'installation

Masquer les pouces Voir aussi pour BRIDGE 4100:

Table des Matières

Les langues disponibles

06DE2143A installatore Segn.pmd

MANUEL D'INSTALLATION BRIDGE 4100

MANUEL D'INSTALLATION

POSITIONING THE COMPONENTS OF THE SYSTEM

All the parts of the system should be installed in hidden locations which are difficult to access

and are wail away from heat sources.

Alarm unit

Fit in the passenger compartment using the double-side adesive material provided. The alarm

unit main connector should exit downwards.

Siren with back up battery

Locate in the engine bay taking care to position it as indicated.

Ø 3 mm.

Siren without back up battery

Fix in the engine compartment, using the screws

provided, to a metal surface to facilitate heat

dissipation.

Bonnet switch

The button must be installed to allow access to the alarm programming procedures and radio

control auto-learning phase.

After installation, check to make sure that the button is depressed at least 5 mm by the bonnet.

Make sure that the button does not press against soundproofing panels or against the outer

bodywork of the vehicle as these materials could deform over a period of time.

FITTING INSTRUCTION BRIDGE 4100

FITTING INSTRUCTION

20/10/2005, 12.15

Table des Matières