SCS Sentinel Kit automatisme vérins Manuel D'installation Et D'utilisation page 68

EN
> PosITIonIng youR eleCTRICAl CABIneT
Gather all the wires of your electrical cabinet.
On no account should any wire arrive from the top or the side of the cabinet.
Open the
(Figure 1)
1
- remove the 4 screws
- remove the front panel
Place your cabinet where
2
you want to fix it
Position and mark the
points for the 4 screws.
3
Drill and plug the bearing
surface at these four points.
Fix your cabinet (screws and
4
wall plugs not supplied).
Fit the rubber seal in the groove
provided for the purpose. the
ends of the seal should be
5
placed at the bottom of the
cabinet to allow the water to
run off if necessary.
(Figures 2)
en ::: 22
FIguRe 1
electronic box
FIguRe 2
Top
Cables
Seals or
compression
glands
(not supplied)