Installation - SCS Sentinel Kit automatisme vérins Manuel D'installation Et D'utilisation

EN

INStAllAtION

> FITTIng dIMensIons
Install two fastenings for the worm screw, respecting the below fitting dimensions.
Before fixing your motors and depending on the opening angle you need (in degrees °), calculate the
position of your motors on the pillars and on the gate.
Measurements to respect
A
B
C
A. gap between the gate's axis of rotation and the arm's axis of rotation (widthwise).
B. gap between the gate's axis of rotation and the arm's axis of rotation (depthwise).
C. Distance between the two arm fasting points. For this the arm must be deployed.
en ::: 18
- top view -
For a 90° opening
120 mm
160 mm
960 mm
For a 120° opening
130 mm
110 mm
960 mm