SCS Sentinel Kit automatisme vérins Manuel D'installation Et D'utilisation page 54

EN
operate it by hand......
Concrete supports must be made in accordance with good practice; if necessary, call in a professional.
you cannot automate a gate or door in poor condition or incorrectly installed. If you have any doubts,
call in a professional.
>
recommendations on installing your automation system
Incorrectly treated or damaged parts must be returned to us for verification or repair.
- Check that the motion space of moving parts (worm screw, arm or slider) is unobstructed through
time and unhindered (cut back shrubs or hedges if necessary).
- Do not make any modifications to parts of this automation system that are unauthorized in this manual.
Such alterations may make it very dangerous to use. The manufacturer accepts no responsibility for
any damage caused by such alterations and will void the warranty.
- All installation and maintenance work must be carried out with the power supply and optional battery
disconnected (indicate your presence in a place where people are constantly coming and going
with a sign, for instance).
- Always use appropriate tools in good condition.
- Fixed and moving parts must be securely attached, in accordance with good practice and be stable
over time.
- When installing the system, do not expose parts of the kit to rain or excessive heat. Using the automation
system in such cases can cause serious danger.
- Do not immerse the parts of this automation system in water or any liquid substance. Using the
automation system in such cases can cause serious danger.
- If liquid substances penetrate this automation system, disconnect it immediately and observe the
safety instructions specific to the power network. Using the automation system in such cases can cause
serious danger.
- the installer should check that the conditions of temperature when in use are met.
- The installer must ensure that the manual disengagement device is always accessible.
- The installer must ensure that moving or fixed parts are sheltered from possible knocks (if necessary
protect them).
Moving parts must be unhindered and move freely.
- The installer has a duty to check that there are no areas where people could be crushed or cut. he
must fit all the safety parts needed to eliminate such problems (see following chapter).
- The alignment of the photoelectric cells is very precise; make sure their fastenings are stable and on
a flat surface.
- The flashing light is recommended but not mandatory, and must be visible from the road.
en ::: 8