SCS Sentinel Kit automatisme vérins Manuel D'installation Et D'utilisation page 58

EN
>
maintenance
- Keep the installation in perfect working order (electrical, mechanical and prescriptive) and regularly
check the condition and serviceability of all components.
We advise you to check your automation system and the safety devices every 6 months at most and
after each fault or external intervention.
this kit needs no lubrication. you should check the condition of fastenings and electric cables and
carry out a full test of safety devices (photoelectric cells, flashing light, stop on obstacle, sensor bar,
emergency stop, etc.).
Check the condition of the hinges for a swing gate, the wheels for a sliding gate and the slides for a
garage door (lubricate them if necessary).
ReMIndeR: do noT FoRgeT To CuT oFF The 230 v PoWeR suPPly ~ And The BATTeRIes
BeFoRe doIng Any WoRk on MoToR unITs oR PoWeR suPPlIes.
- to guarantee the product's optimal performance, it is essential that the persons installing this
automation system comply with current legislation and safety rules.
- Installation and cleaning tasks must be documented (see next page). this documentation must be
kept by the user and put at the disposal to competent personnel provided for the purpose.
doCuMenT To FIll In FoR The MAInTenAnCe oF youR AuToMATIon sysTeM >>
As referred to earlier, you must check your automation system at regular intervals, every
6 months at most, and keep a record of the points you have checked and of your remarks.
This automation system must be checked and maintained by a qualified and specialized person
in accordance with current standards in the country of use.
a - Turn off the power supply (and disconnect the optional batteries) then check the electrical
wiring, the fastenings and the wear parts. All worn or damaged parts must be replaced.
b - Turn on the power supply and carry out a thorough check of the safety devices:
Remote controls: Check the range of the remote control, if necessary change the battery
Flashing light: Check that it is in good working order, in good condition and can be seen from the
road.
Photoelectric cells: check that they work properly with the closing movement and that they are
in good condition.
stopping on an obstacle: Place a 15 kg weight in the passage at the end of the leaf (a sandbag
or bucket of water for instance). When closing, the gate should stop.
lighting of the gate's motion space: Check it is in good condition and working order, if necessary
change the bulb.
en ::: 12