SCS Sentinel Kit automatisme vérins Manuel D'installation Et D'utilisation page 65

> PosITIonIng The ARMs on The PIllAR
Choose the best place on the leaf to position the front fastening of the motor at the right height.
As far as possible, place at halfway up the leaf. Generally, the ideal point is always the most solid area
of the leaf and least liable to bending.
Avoid fitting it near the ground to make it easier to unlock the system manually. Do not drill holes
in the pillar or gate before accurately determining the location of the elements, in accordance
with the fitting dimensions specified on page 16.
The mounting plate must be fixed to the brick
wall with M8 screws (not supplied) and expansion
plugs 15 mm in diameter (not supplied), in steel
or cast iron (fastening 1).
Depending on the material of your pillar, this
may not be relevant.
If in doubt, seek advice from your sales adviser.
The motor fastenings can be used in many posi-
tions: the fastener on the pillar side lets you easily
adjust dimension B.
> PosITIonIng The ARMs on The PIllAR
Place the operator on the fastening with the aid
of the screw (fastening 1). Place the first washer
under the screw head and the other under
the nut. tighten the supplied locknut without
blocking the motor.
handle the operator with care when mounting or dismantling it from the corresponding
housings, to avoid any accident or damage to the equipment. If it is too tight, this can
damage the motor's rear retaining bracket.
en ::: 19
EN
FAsTenIng 1
FAsTenIng 1