Installing And Removing The Battery Pack - Craftsman CMCST910 Guide D'utilisation

English
or accessories, when replacing line, or prior to
cleaning. An accidental start-up can cause injury.

WARNING:
protection that conforms to ANSI Z87.1 (CAN/CSA
Z94.3) while operating this appliance.

WARNING:
making any assembly, adjustments, or changing
accessories. Such preventive safety measures reduce
the risk of starting the trimmer accidentally.

CAUTION:
use the appropriate type of cutting line.

CAUTION:
remove any wire, cord, or string-like objects which
could become entangled in the rotating line or spool.
Be particularly careful to avoid any wire which might
be bent outwardly into the path of the appliance, such
as barbs at the base of a chain link fence.

Installing and Removing the Battery Pack

(Fig. E)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button 13 and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
Fig. E
12
Proper Hand Position (Fig. F)

WARNING:
personal injury, ALWAYS use proper hand position
as shown.
8
Always use proper eye
Remove the battery before
Before you begin trimming, only
Inspect area to be trimmed and
12 into the tool handle, align the
13
To reduce the risk of serious

WARNING:
personal injury, ALWAYS hold securely in anticipation of
a sudden reaction.
Proper hand position requires one hand on the main
handle 14 and one hand on the auxiliary handle
Fig. F
4
Switching Trimmer On and Off (Fig. A)

WARNING:
trigger in the on position.
To turn the appliance on, squeeze the lock-off button
and then the trigger 1 . Once the unit is running, you may
release the lock-off button. To turn the appliance off, release
the trigger.
Trimming (Fig. G, H)
With the trimmer on, angle it and swing side to side as
shown in Figure G.
Maintain a cutting angle of 5° to 10°. Do not exceed 10°. Cut
with the tip of the line.
Maintain a minimum distance of 24" (610 mm) between the
guard and your feet as shown in Figure H.
Fig. G
To reduce the risk of serious
4 .
14
Never attempt to lock the
2