Panel Installation - Carel MasterCella compact Manuel D'utilisation

1.2 Panel installation

In reference to Fig. 1.2.1 and the corresponding parts:
1. Make a hole in the panel with the following dimensions: 182x153mm.
2. Unscrew the two frontal screws (Fig. 1.2.1, a, b) and take out the central door (part c).
3. Unscrew the two screws (parts d, e) that keep the lower and frontal cover of the MasterCella connected
and separate the two parts.
4. Insert the panel gasket in the front panel, on top of the internal gasket.
5. Make two holes in the back part (Fig. 1.3.1 in the perforated part - parts f, g).
6. Join the back part and the front, with the panel in between, and fix the whole unit with the two screws
(dimensions: 4x20*mm) that are contained in the kit.
* max length 20 mm.
Warning: the two upper fastening teeth (part h) must be removed from the front panel before inserting the
unit in the panel. Make the hole on the upper (part i) or lower part (part l) of the rear for the passage of the
cables. The step of the thread can vary from PG9 (diameter 16mm) to PG21 (diameter 29mm).
A drill or miller should be used to assist the drilling operation. Connect the wires to the terminal block.
Retighten the screws (parts d, e), then close the door (part c).
d
a
compact
prg
SET
MasterCella MasterCella
24
i
l
e
c
b
h
Fig. 1.2.1