Important; General Characteristics - Astralpool 41636 Manuel D'installation Et D'entretien

ENGLISH
IMPORTANT: The instruction manual you are holding includes essential information on the safety measures to be implemented for installation
and start-up. Therefore, the installer as well as the user must read the instructions before beginning installation and start-up.
Keep this manual for future reference.
To achieve optimum performance of the led projector, follow the instructions indicated below:
1. VERIFY THE CONTENTS OF THE PACKING
The following accessories are included inside the box:
Leds Projector
Directional fastening system (2 sets)
Installation and maintenance manual
THIS PRODUCT DOES NOT CONTAIN ANY ELEMENTS THAT CAN BE HANDLED, DISMANTLED OR REPLACED BY THE USER. IT IS FORBIDDEN
TO ACCESS INSIDE THE PRODUCT, OTHERWISE THE GUARANTEE OF THE PRODUCT WILL BECOME INVALID.

2. GENERAL CHARACTERISTICS

This lamp is designed for use outdoors or totally submerged. It is a Class III electric apparatus with very low safety voltage (12 V with alternating
current).
The floodlamp compiles with IPX8 degree of protectlon (resistance to penetratlon of dust, solld bodies and humidlty) at a nominal Immersion depth
of 2 m.
This floodlamp compiles with international safety standards for lights, especially the EN 60598-2-18 standard. LIGHTS PART 2: SPECIFIC
REQUIREMENTS SECTION 18 LIGHTS FOR SWIMMING POOLS AND SIMILAR APPLICATIONS.
The mains supply to the light should have 30 mA overload protection. The power supply transformer of these projectors must be an insulated safety
transformer with separate spooling.
The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any eiectric components which have been inserted
or handied at locations other Ihan its own premises.
3. INSTALLATION
Connection boxes should be at least 2 m. from the edge of the fountain or water installation.
The 230/12V transformer, which supplies the lamp, should be installed at a distance of 3.5 m. from the edge of the water installation.
The conduits installed less than 3.5 m. from the edge of the water installation, should not be lined or covered with metal.
4. ASSEMBLY
A. Ensure that the lamp is NOT receiving electrical voltage.
B. Insert the fastening brackets in the centre groove of the projector, tighten using an N3 Allen wrench.
C. Place the projector in position and use the 10 fastening drill holes as a template to mark the anchorage drill holes. The surface should be flat and
even.
Fastening System
Fig. 1
Ground
Fig. 3
Fig. 2
2