Sony Trinitron Multiscan17seII Mode D'emploi page 10

Adjustments
Canceling the Moire
(GDM-20SE2T only)
The adjustment data becomes the unique setting for the
input signals received.
1
Press the OPTION button.
The OPTION OSD (On Screen Display) appears.
OPTION
2
Press the ¨ ./> buttons to select "CANCEL MOIRE"
and then press the > / button.
3
Press the > ?// buttons to select "ON" and then
press the ¨ . button.
4
Press the > ?// buttons to adjust for minimum
moire.
To erase the "CANCEL MOIRE" OSD, press the OPTION
button again.
The OSD automatically disappears 30 seconds after you
release the buttons.
To reset, press the RESET button while the OSD is on.
Note
When the moire is cancelled, the picture may be fuzzy.
Adjust the moire gradually from 0, and stop the adjustment
as near to 0 as possible.
10
COLOR TEMPERATURE
CANCEL MOIRE
INPUT: HD1 5 BNC
LOCK: UNLOCK LOCK
80.0KHz/ 75Hz
SELECT SET
CANCEL MOIRE
OFF ON
31
SET
CANCEL MOIRE
OFF ON
31
SELECT SET
Switching the Input Connector
As the monitor has two sets of input connectors, you can
switch between two input video signals. It is necessary to
select the connector type (HD15/5 BNC's) correctly
according to the connection.
1
Press the OPTION button.
The OPTION OSD (On Screen Display) appears.
OPTION
2
Press the ¨ ./> buttons to select "INPUT" and then
press the > ?// button to select "HD15" or "BNC."
When you switch between input sources, the monitor screen
is muted for a moment (Mute) then the signal through the
selected input is displayed. If the selected input do not
receive any video signals, the monitor automatically returns
to the other input after Mute and the OPTION OSD appears.
To erase the OPTION OSD, press the OPTION button again.
The OSD automatically disappears 30 seconds after you
release the buttons.
If two computers are connected to the monitor (one to each
input), when one of the computers is turned on or restarted,
or the monitor goes into power saving mode, the monitor
may switch to the other input because the signal is
temporarily interrupted. Select the input which you use,
following the above steps.
COLOR TEMPERATURE
INPUT:
HD1 5 BNC
LOCK: UNLOCK LOCK
80.0KHz/ 75Hz
SELECT SET
/