Items Supplied - EINHELL FBK 62A Instructions De Montage

Anleitung FBK 62 A - FBK 120 A
GB

1. Items supplied

a) FBK 62 A (Fig. 1)
1 Hinged cold frame - assembled
1 Plastic assembly set
Replacement part no.: 36.804.10.01.021
(4 assembly corners, 4 earth anchors, 6 clips, 2
hood corner pieces)
a) FBK 120 A (Fig. 2)
1 Side panel (Fig. 2 / Pos. 1)
Replacement part no.: 36.806.60.01.001
2 Hoods (Fig. 2 / Pos. 2)
Replacement part no.: 36.806.60.01.002
1 Central hinge profile (Fig. 2 / Pos. 3)
Replacement part no.: 36.806.60.01.003
4 Hinge clamps (Fig. 3 / Pos. 4)
Replacement part no.: 36.806.60.01.004
2 Plastic assembly sets (Fig. 3)
Replacement part no.: 36.804.10.01.021
(each with 4 assembly corners, 4 earth anchors,
6 clips, 2 hood corner pieces)
2. Choosing a place in the garden
Choose a place in the garden for your cold frame.
The cold frame must be screwed to a level
foundation, or the ground must be level around the
area of the side panel, so that it can be fixed to the
ground with the earthing clamps (Fig. 3 Pos. 8).
3. Assembly
For the purposes of assembly, you will need a light
hammer and some pincers.
(Fig. 4) Unfold the side panel, press the 4 lower
corners of the side panel into the assembly corners
(5).
(Fig. 5) Only applies to FBK 62 A: On both sides,
slide the aluminum profile (h) over the hinge (k) of
the side panel. In doing so, the hinge is fixed to the
upper edge.
(Fig. 6) Only applies to FBK 120 A: On both sides,
connect the aluminum profile (a) of one half of the
cover to the central hinge profile (3) using a hinge
clamp (4). Repeat for the second half of the cover.
(Fig. 7) Only applies to FBK 120 A: On both sides
of the cover, push an assembly corner (5) into the
groove (b) on the aluminum profile. Fold down the
6
06.10.2004 14:18 Uhr Seite 6
cover.
(Fig. 8) Only applies to FBK 120 A: On both sides
of the side panel, push the assembly corner (5) into
the groove (c) on the central aluminum profile.
(Fig. 9) Slide the cover corners (6) onto both corners
of the cover.
(Fig. 9a) Fix the cover corners to the underside of the
cover with a 2.9x6.5 screw.
(Fig. 10) Push the clips (7) on the side halves. Three
openings can be inserted in each side of the cold
frame. Preferably, one completely opened, one
completely closed and one individually adjustable
opening.
At the same time, the cover corners (6) are pushed
into the clips (7).