Publicité
Les langues disponibles
Les langues disponibles
▪
Put the battery cover back in place and retighten the screw.
▪
Check the remote control operates correctly:
Press a button: if the indicator light located on the front of the remote control flashes green, the battery is properly inserted. If the
indicator does not light, remove the battery and check the polarity before inserting it once again (ref. Diagram 5: "+" noted on the
battery must be visible).
"+" of the battery
must be visible
● Checking/replacing battery of receiver collar
To check the condition of the battery, observe the indicator light located on the front of the receiver collar:
▪
Battery fully charged: flashes slowly green.
▪
Weak battery: flashes quickly red.
Replace it with a new 3-V Lithium CR2 battery (See § First use from new: Fitting the battery in the receiver collar). Check the receiver
collar operates correctly.
● Changing the contact points
Two different series of contact points are supplied. The length of the contact points must be sufficient to have proper contact with the dog's
skin, enabling the device to operate correctly.
If you have a long-haired dog and the short contact points fitted to the collar in the factory are inadequate, remove and replace them with the
long ones supplied with the kit.
Carefully tighten them manually (do not use a key).
● How to check that your product is functioning properly
▪
Before doing so, make sure that the receiver collar is turned "Off" (indicator light off).
▪
Place the neon test lamp in contact with each of the contact points (by unscrewing them, then by screwing them up in order to grip
wires of the lamp under the contact points).
▪
Turn "On" the remote control and receiver collar.
▪
Press the "1" button then modify the level of intensity of the static corrections by pressing the buttons 2 to 5: the test lamp must come
on with more or less intensity.
● Getting the best results
The training instructions you send to your dog are sent from the remote control to the receiver collar by radio waves.
These radio waves are sensitive and the range reaches approximately 250 yards (depending on geography and environment).
The performances of you product will be optimal if you respect the following recommendations:
▪
To obtain a good radio range, do not cover the part located above the buttons when you hold the remote control in your hand.
▪
The position of the receiver collar around the neck of your dog should be in the following way: the "On/Off" indicator light is visible and
is not in contact with the breast of the dog.
▪
Check the batteries (remote control and receiver collar) before using the unit and replace them as soon as the level of load is weak.
▪
The performances of the batteries decrease slightly under temperatures lower than 32 Ft. If possible, keep the remote control warm
(e.g. inside a pocket) before using it.
● Fitting the collar
Diagram 5
- 4 -
Publicité
