EYENIMAL RT 250 Guide D'utilisation page 6

User's guide
● Contents of the product
- 1 250 Remote Trainer receiver collar equipped with short contact points and a strap
- 1 lithium 3-V CR 2 battery for the collar
- 1 250 REMOTE TRAINER remote control equipped with 1 lithium 3-V CR 2430 battery
- 1 neon test lamp
- 1 pair of long contact points
- 1 carry strap
- this user's guide
● Description of the product
Beeper
button
Continuous
static correction
level 2
Continuous
static correction
level 4
● First use from new
 Fitting the battery in the receiver collar
▪
Unscrew the 4 screws of the top of the collar using a screwdriver.
▪
Insert the battery (3 Volt CR 2 Lithium) paying attention to follow polarity indicated on the battery housing (ref. Diagram 3).
▪
A beep sound (low pitch) is emitted, indicating the correct installation of the battery.
If you do not hear any beep after having inserted the battery, remove it immediately from its housing. Check the polarity before trying
again.
▪
Before putting the lid back in place, check that the rubber seal is in its groove.
▪
Screw up the 4 screws with care (do not over tighten them).
Indicator of radio transmission
REMOTE CONTROL
Diagram 1
+ Battery level indicator
Continuous static correction
level 1
Continuous static correction
level 3
Continuous static correction
level 5
Red mark:
area where the
On/Off switch
magnet is located
2 contact points
(short or long)
RECEIVER COLLAR
Diagram 2
On/Off indicator
+
Indicator of
radio reception
+
Battery level
indicator