EYENIMAL RT 250 Guide D'utilisation page 8

 Coding of the remote control and receiver collar
Each remote control has its own individual radio operator code. The coding of the remote control with the receiver collar enables the two units
to work together.
IMPORTANT: before beginning the coding, make sure no other person is using his 250 REMOTE TRAINER or other products from the
EYENIMAL range close by: your receiver collar could accidentally record the code of his remote control. If that occurs, re-code the remote
control with the receiver collar.
CODING PROCEDURE
To code, the remote control must be ready for use (battery in place).
1. Receiver collar in position "deactivated" (indicator light off): move the remote control towards the collar so that the red mark on the
remote control comes into contact with the red mark on the receiver collar, hold for 6 seconds. The indicator on the receiver collar
lights in fixed green, then flashes in red.
2. Move the remote control away from the receiver collar.
3. Press the beeper button
control.
 Reprogram a receiver collar
The receiver collar can be re-coded indefinitely, either with the same remote control, or with a new one from the EYENIMAL range (Ref. Re-
coding procedure).
● How to use the remote control
The 250 REMOTE TRAINER remote control is designed to operate with one receiver collar.

button: beeper
If you press the "Beeper" button
beeper will continue to sound for as long as the button is pressed.
It's up to you to use the beeper button depending on the way you want to train your dog.
With the beeper button you can:
- send a sound to your dog when it is disobedient,
- draw its attention, ...
It's very important to always use the beeper in the same way in order not to disturb your dog.
 1 to 5 buttons: continuous static corrections
Button 1: lowest static correction / Button 5: strongest static correction
Press the button 1, 2, 3, 4 or 5 to send a warning to your dog using static corrections transmitted by the two contact points located on the
receiver collar, the warning will last for as long as the button is pressed but limited to 8 seconds maximum.
● Checking/replacing battery of remote control
To check the condition of the battery, observe the indicator light located on the front of the remote control. If the light indicator flashes
green 3 times when you press a button, the battery is weak.
Performance (radio range) of the remote control deteriorates as battery becomes weak. You should soon replace the battery.
When the battery is empty, you cannot use the remote control. If pressing a button, the LED located on the front of the remote control
will not light.
Replace the old battery with a new one as follows:
▪
On the back of the remote control, unscrew the screw and remove the battery cover.
▪
Remove the old battery.
▪
Insert the new battery (3-V CR 2430 lithium) making sure the polarity "+" noted on the battery is visible (ref. Diagram 5).
of the remote control. A beep sound is emitted; the receiver collar is then synchronized with your remote
on the remote control, the receiver collar will emit sound signals. There is no time limit for this function: the
- 3 -