Range Hood Care; Cleaning - KitchenAid LI315F Instructions D'installation Et Guide D'utilisation Et D'entretien

To Set Auto Sense:
Press AUTO.
To Select Auto Sense Cooktop Type:
NOTE: The range hood is factory-set for the gas cooktop
mode.
1. Press and hold AUTO for 5 seconds to switch between the
gas cooktop and electric cooktop modes.
2. The Auto button light will flash five times when the range
hood is changed to the electric cooktop mode. Auto Sense
is now set to work with electric cooktops and ranges.
3. The Auto button light will flash three times when the range
hood is changed to the gas cooktop mode. Auto Sense is
now set to work with gas cooktops and ranges.
4. Changing the cooktop type will change the temperature limit
for Auto Sense to turn on. When the range hood senses a
high enough temperature, the fan will start automatically.
When the temperature drops below the set temperature limit,
the fan will stop automatically. The Auto button light will turn
off after the range hood enters Sleep Mode, but Auto Sense
is still active.
To Deactivate Auto Sense:
1. If the Auto button is lit, press AUTO once to deactivate Auto
Sense. The Auto button light will turn off.
2. If Auto Sense is in Sleep Mode, press AUTO once to
deactivate Sleep Mode and turn the Auto button light on.
Press AUTO again to deactivate Auto Sense and turn off the
Auto button light.
3. Auto Sense will automatically turn off after 2 hours of no
activation of the Auto Sense system. To reset Auto Sense,
press AUTO.
IMPORTANT: Clean the hood and grease filters frequently
according to the following instructions. Replace grease filters
before operating hood.
Exterior Surfaces:
To avoid damage to the exterior surface, do not use steel wool
or soap-filled scouring pads.
Always wipe dry to avoid water marks.
Cleaning Method:
Liquid detergent soap and water or all-purpose cleanser.
■
Wipe with a damp soft cloth or nonabrasive sponge, and
■
then rinse with clean water and wipe dry.
Metal Grease Filter
1. Open the stainless steel panel. Grasp panel at the front
corners, and then pull down to disengage the two catch pins
from the spring catches. The panel is attached at the rear
and will rotate down.
12
The range hood can be set to automatically turn off after 15
minutes.
1. Press and hold the desired fan speed button for 2 seconds.
2. Press the desired fan speed button again while the fan timer
The range hood has both task and ambient lighting.
To operate the lights:
1. Touch LIGHT ON/OFF once, and the LED task lights will turn
2. Touch LIGHT ON/OFF again, and the LED task lights will turn
3. Touch LIGHT ON/OFF a third time, and the ambient lights will

RANGE HOOD CARE

Cleaning

Manual Vent Functions
Fan Speeds
Low Press LOW to turn the fan on at Low speed.
Med
Press MED to turn the fan on at Medium speed.
Hi
Press HI to turn the fan on at High speed.
Boost Press BOOST to turn the fan on at the highest
speed. Boost will automatically turn off after 10
minutes and the fan will switch to High speed.
Timer
The fan will run on the chosen speed for 15 minutes, and
the fan speed button light will flash continuously. After 15
minutes, the fan will turn off automatically.
is running to cancel the fan timer.
NOTE: Changing the fan speed or turning Auto Sense on will
also cancel the 15-minute timer.
Light
on.
off. The ambient lights will turn on.
turn off.
NOTE: To turn both the task and ambient lights on at the
same time, touch and hold LIGHT ON/OFF for 2 seconds.
Touch LIGHT ON/OFF again to turn the task and ambient
lights off.
A
B
A. Metal filters
B. Stainless steel panel
D
C
C. Catch pins (2)
D. Spring catches (2)