Publicité
Les langues disponibles
Les langues disponibles
TAVOLI REFRIGERATI
ENG
15. Switching on and turning off
To turn the refrigerator on it is sufficient to activate the switch in the ON position with green light on.
The display will flash for 3 seconds, then it will report the temperature inside the cell and begin the cycle
refrigerator. During the course of this operation, the display you will show the LED light near the
snowflake (No. 5) and the LED light of the internal fan. (# 4)
To turn the refrigerator off it is sufficient to activate the switch in the OFF position with green light off.
15.1 Setpoint setting
To display the setpoint value press the 8 key: "set" will appear. Pressing again the 8 key it will be shown
the default value of the setpoint on the display. To change the setpoint value act on the 1 and 2 keys
within 15 seconds. To confirm the change, press the 10 key.
With setpoint it is meant a temperature value to be achieved from the food with a tolerance of 2°C higher.
15.2 Manual defrosting
To activate manual defrost it is sufficient to hold the 1 key for 5 seconds, then all the led will turn off and
it will light up the LED No. 5 and it will begin the defrost cycle.
TROUBLESHOOTING
LABEL
TROUBLE
Probe 1 broken
E1
Probe 2 broken
E2
(defrosting)
HIGH alarm
AH1
Temp. probe 1
CAUSE
• reading of values
outside of the range
of operation
(cell)
• broken probe /
short-circuit / door
open
• reading of values
outside of the range
of operation
• broken probe /
short-circuit / door
open
Fridge temperature
too much elevated
RESULT
•Label E1
•Steady Alarm Icon
•Label E2
•Steady Alarm Icon
•The defrosting cycle will
end for time-out
•No effects on regulation
Ed.10/2011
SOLUTION
•Check probe type (NTC)
•Check probes wiring
• Substitute the probe
•Check probe type (NTC)
•Check probes wiring
•Substitute the probe
Wait the temperature
value red from probe 1
goes down of HAL.
16
Publicité
