Fit The Receiver Collar - Petsafe PDT20-11939 Manuel D'utilisation

Step

Fit the Receiver Collar

Important: The proper fi t and placement of your Receiver
3
Collar is important for effective operation. The Contact
Points must have direct contact with your dog's skin on
the underside of his neck.
To assure a proper fi t, please follow
these steps:
1. Make sure that the Receiver Collar is
turned off.
2. Start with your dog standing
comfortably (3A).
3. Place the Receiver Collar on your dog's
neck close to the
ears. Centre the
Contact Points
underneath your
dog's neck, touching
the skin (3B).
Note: It is sometimes
necessary to trim
the hair around
the Contact Points
to make sure that
contact is consistent.
Longer probes are
also available through
our Customer Care
Centre. For a listing of
Customer Care Centre
telephone numbers, visit our website at www.petsafe.net.
4. Check the tightness of the Receiver Collar by inserting one
fi nger between the collar and your dog's neck (3C). The fi t
should be snug but not constricting.
5. Allow your dog to wear the Receiver Collar for several minutes
then recheck the fi t. Check the fi t again as your dog becomes
more comfortable with the Receiver Collar. Note: If your dog is
young and you expect him/her to grow, you'll want to leave excess
strap to adjust the collar fastening. Replacement straps are available
through our Customer Care Centre. For a listing of Customer Care
Centre telephone numbers, visit our website at www.petsafe.net.
12
3B
3C
www.petsafe.net
3A