Petsafe PDT20-11939 Manuel D'utilisation page 10

3. Plug the Universal Charging Adapter
into a standard household electrical
socket, using the appropriate
adapter plug.
4. Charge the Receiver Collar until the
Green Indicator Light comes on and
is solid. Recharges take only
3-4 hours.
5. When charging is completed replace
the rubber cover.
_________________________________________
To Turn the Receiver Collar On
1. Press and hold the On/Off button until the Green LED comes on and the
Receiver Collar beeps low to high.
2. Release the On/Off button. The Green LED will fl ash once every 5 seconds
until the Receiver Collar is turned off. The fl ashing light indicates the
Receiver Collar is ready to receive a radio signal from the
Remote Transmitter.
3. Once the Receiver Collar has been turned on, press the Upper Left button
of the Remote Transmitter. Upon pressing, the Receiver Collar should beep
for as long as the Upper Left button is pressed. If it does not, see "To Pair
the Remote Transmitter and the Receiver Collar". Note: To extend the life of
the battery, turn the Receiver Collar off when it is not in use.
350 metre Little Dog
Receiver Collar
On/Off Button
To Turn the Receiver Collar Off
1. Press and hold the On/Off button until the Red LED comes on and the
Receiver Collar beeps high to low.
2. Release the On/Off button. To extend the life between charging cycles,
turn the Receiver Collar off when it is not in use. Approximate battery
life between charges is 40-50 hours, depending on frequency of use.
10
900 metre Big Dog
Receiver Collar
900 metre Big Dog
Receiver Collar
www.petsafe.net
Charger
connector
placed in
Receiver
Collar
Charging
Jack
On/Off
Button