Petsafe PDT20-11939 Manuel D'utilisation page 7

Turning ON the Transmitter
Power up the Transmitter by pressing any button. You will see the
display turn on when you press any button.
Transmitter Digital Display
The display stays on for 10 minutes after a button press. After 10
minutes with no button presses, the display shuts off and the transmitter
goes into battery conservation mode. Pressing any button will cause
the display to turn back on. The various symbols you might see on the
display are explained below.
Note: Factory default setting is for Dog 1 mode, you will not see the Dog 2
symbol unless the unit is programmed for Dog 2 (see Two Dog System
on page 14).
Numeric
readout
Dog 1/
Dog 2
Tone or
Stimulation
Battery
Indicator
www.petsafe.net
Shows the chosen stimulation level for
Dog 1 or Dog 2.
The symbol displayed is the active dog
receiver collar. See Two Dog System
on page 14.
When pressing Tone or Stimulation
the Dog 1 or Dog 2 symbol will appear
in bold or emphasized.
The battery indicator provides
constant awareness of your battery's
power level. See the next section for
more detailed information on the
Battery Indicator.
7