HEBU medical HBS x-touch 300 argon Mode D'emploi page 46

EN
•
Connect the hose (D) of gas cylinder 1 to
connection point 1 (25) and the gas pressure
measurement line (E) from the valve to terminal
26. Connect the hose (G) of gas cylinder 2 to
connection point 2 (27) and the gas pressure
measurement line 2 (F) to the corresponding
terminal 28.
the HBS X-touch 300 argon automatically switches to the full gas
Argon gas regulator
If you are working with argon please ensure that the argon gas regulator on the gas bottle is fully
open (position "+").
Connecting the handle for argon
Activation of the argon function
46
When the pressure in the active gas cylinder drops to below 5%
cylinder. If both cylinders are empty, the message "Argon level
LOW" appears on activation at the display.
Connect the handle to "MONOPOLAR2" and the hose connector
(of the handle) to the argon connection point.
To set the argon function you have to press the "Argon Flow"
button on the touch-screen. If it is activate, "+Argon" will
appear.
HBS x-touch 300 argon