KOBE Premium Série Manuel D'installation Et Mode D'emploi page 11

Wiring to Power Supply
SAFETY WARNING
14. Connect electrical wires.
15.
16.
Hood Installation
NOTE: USE HAND TOOLS ONLY.
SCREWS, MAY CAUSE DAMAGE TO THE HOOD.
17. Remove the light panel by removing 10 screws located at the
bottom of the hood (Refer to Figure 11). Carefully remove the
light support panel.
18. Position the hood inside the custom wood frame, and secure the
hood to the front and rear stud support ( Refer to Figure 2) by
using the front and rear mounting holes (Screws included).
19. For a more secure installation, use the mounting holes located
on the side of the hood
20. Make sure hood is secure before releasing.
21. Re-install the light support panel. (Do not over tighten screws.)
CAUTION
: MAKE SURE HOOD IS SECURE BEFORE
RELEASING
DO NOT OVER TIGHTEN
9
Figure 9
Figure 10
Figure 11