KOBE Premium Série Manuel D'installation Et Mode D'emploi page 10

For Rear Vent Options only:
NOTE: The blower is pre-installed for top vent. If
installing as rear vent, follow the steps below.
9. For Rear 6" round installation only:
Remove the Rear Round Vent Cover and Rear
-
Rectangular Vent Cover (Refer to Figure 4). Keep screws
to attach Round Exhaust Plate to rear vent.
Remove the pre-installed Round Exhaust Plate from top
-
vent (Refer to Figure 5). Attach it to the rear vent (Refer to
Figure 7) using the screws removed from vent covers.
Use the Round and Rectangular vent covers removed
-
from rear vent to seal top vent.
Remove the 4 screws that secure the blower system
-
(Refer to Figure 8). Hold the blower to keep it from
dropping as you remove screws. Keep screws to re-attach
blower. Slowly rotate blower system to align with mounting
holes at the back of the hood. Secure blower using 4
screws (Refer to Figure 9).
10. For Rear 3-1/4" x 10" rectangular installation only:
Remove the Rear Round Vent Cover and Rear
-
Rectangular Vent Cover (Refer to Figure 5). Keep screws
to attach Rectangular Exhaust Plate and Rectangular
Exhaust Adapter.
Place the Rectangular Exhaust Plate over vent and secure
-
with 2 screws (Refer to Figure 10). Place Rectangular
Exhaust Adapter over the Rectangular Exhaust Plate and
secure with 10 screws (Refer to Figure 10).
Use remaining screws to secure exhaust plate.
-
Remove the pre-installed Round Exhaust Plate from top
-
vent and keep screws (Refer to Figure 4). Use the Round
and Rectangular vent covers removed from rear to seal top
vent.
Remove the 4 screws that secure the blower system
-
(Refer to Figure 8). Hold the blower to keep it from
dropping as you remove screws. Keep screws to re-attach
blower. Slowly rotate blower system to align with mounting
holes at the back of the hood. Secure the blower using 4
screws (Refer to Figure 9).
Ductwork Installtion
11.
12. steel pipe to connect the exhaust on the hood to the
ductwork above. Use duct tape to make all joints secure and
air tight.
13.
Figure 5
Figure 6
Figure 7
Figure 8
8