Sharp PN-70TA3 Manuel D'installation page 11

Turning Power On/Off (Continued)
Calibration
Calibration is used to perform position alignment so that the
mouse cursor moves to the correct position when the screen
is touched.
Before initial use, perform calibration.
1. Set the input to WHITEBOARD.
2. Touch the launch button.
Launch button
The launcher appears.
3. Touch [Setting].
You will be prompted to enter a password.
4. Enter the password and touch [OK].
Enter the password set in the Admin Password. If a
password is not set, enter "00000".
5. Touch [Admin Settings] and [Calibration].
6. Follow the instructions on the screen to perform
calibration.
TIPS
• If you will be using the touch panel with a computer,
perform calibration from the Touch Panel Settings Tool.
For details, see the Touch Panel Settings Tool Operation
Manual.
Turning power off
The power can be turned off in the following ways.
(1) Press the POWER button.
The monitor enters whiteboard standby mode.
This method allows faster startup and shutdown than (2),
however, more power is consumed while in standby mode.
(2) Hold down the POWER button until the exit screen
appears.
The monitor enters standby mode. The WHITEBOARD is
in the shutdown state. More time is required for shutdown
and startup than (1), however, less power is consumed in
standby mode.
Before switching off the main power switch, always put the
monitor in the Power off (Standby mode) state.
Caution
• When the power is turned off, any data on the WHITEBOARD
is lost. If there is unsaved data, a message will appear prior
to shutdown. Save the data.
• If the monitor will be turned off by SCHEDULE, LAN
control, or OFF IF NO OPERATION, save any data you
need in advance. The power will turn off even if there is
unsaved data. (The data will be lost.)
• When turning the monitor power on again, wait at least 5
seconds after shutdown is completed.
• Do not disconnect the power cord, open the breaker,
or switch off the main power switch before shutdown is
finished. Risk of failure.
9
E