HQ Power VDPLW2400 Mode D'emploi page 4

There are 8 modes of self-running programs (value: 1-240) and 1 sound-active mode (value: 241-255) in channel
6.
Chase 1: 1-30
Chase 2: 31-60
Chase 3: 61-90
Chase 4: 91-120
Chase 5: 121-150
Chase 6: 151-180
Chase 7: 181-210
Chase 8: 221-240
Sound-active: 241-255
If the DMX signal exists, the signal in the display panel will flash. The built-in controller will automatically detect
the presence of a DMX signal. In order to receive a DMX signal, the built-in controller must be connected to a
DMX controller trough a 3-pin DMX cable. To mix the RGB colours using the DMX, channel 1 (rainbow) must be
OFF (0). When programming your own DMX sequences, note that channel 6 must be OFF to avoid activation of
the sound-control mode during the playback.
f. DMX Modes
DMX mode 1: 48-channel operation (control each VDPLW2400 independently).
DMX mode 2: 24-channel operation (control 4 sets of 2 VDPLW2400s).
DMX mode 4: 12-channel operation (control 2 sets of 4 VDPLW2400s).
DMX mode 8: 6-channel operation (control all 8 VDPLW2400s).
g. Mounting the Device
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
• The carrying construction must be able to support 10 times the weight of the device for 1 hour without deforming.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified technician
check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
VDPLW2400
4 VELLEMAN