HQ Power VDPLW2400 Mode D'emploi page 3

• Press the F/S button to set the fade and speed values
• Adjust the chase fading time from 0-100%
• Adjust chase speed from 0-500 steps per minute
c. Manual RGB Adjustment
Find the manual RGB adjustment menu by pressing the MODE button. Press F/S to select the
desired colour for adjustment, use UP and DOWN to adjust the value.
The last programme setting will be memorized.
d. Sound-active Operation
In stand-alone mode, select chase 9 and adjust the audio input level using the sensitivity control dial on the rear
panel of the VDPLW2400. In DMX mode, use channel 6 to select sound-active operation.
e. DMX Operation
Press the MODE button to view the DMX address setting menu.
Select the DMX starting address for the built-in controller using the UP and DOWN buttons.
Select DMX channel mode by pressing MODE button to view.
Then press F/S to enter, use UP and DOWN buttons to select.
6-channel mode
6-channel DMX control
Channel 1
Channel 2
Channel 3
Channel 4
Channel 5
Channel 6
VDPLW2400
Indicates RED from dark to bright.
Indicates GREEN from dark to bright.
Indicates BLUE from dark to bright.
Rainbow
Red (0-255)
Green (0-255)
Green (0-255)
Strobe (1-20Hz)
Sound-active
3-channel mode
3-channel DMX control
Channel 1
Channel 2
Channel 3
3
Red (0-255)
Green (0-255)
Blue (0-255)
VELLEMAN