KENMORE ELITE 970-3394 Guide D'utilisation Et D'entretien page 14

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Setting Warmer Drawer Controls
Warmer Drawer & Bread Proofing Indicator Lights
Setting Warmer Drawer & Bread Proofing Controls
Warmer Drawer Food Temperature Settings
Warmer (Warm & Ready™) Drawer & Bread Proofing Indicator Lights
The control and indicator lights for the Warmer Drawer and Bread Proofing features are located on the control panel. The
indicator lights will turn ON when the control is set, and remain ON until the controls are turned OFF.
To Set the Warmer Drawer & Bread Proofing Controls:
1. Touch the
pad at the Warmer Drawer control position. The Warmer
Drawer indicator light will flash. Note: If no further pads are touched within 25
seconds the request to power the Warmer Drawer ON will clear.
2. Set the desired power level. Touch
HI (Fig. 2) or
Drawer indicator light will glow steady indicating the Warmer Drawer is ON.
3. Each touch of the
6 power levels from HI (Fig. 2) to MED (Fig. 3) to LO (Fig. 4) and to the Bread
Proofing feature (Fig. 5). If the Warmer Drawer is set at the LO setting and the
pad is touched again the Bread Proofing feature will be turned ON (The
Bread Proof indicator light will glow steady indicating the Bread Proofing feature
in ON (See Fig. 5 & bread dough preparation instructions on this page). To return
to standard Warmer Drawer settings touch
best results, preheat the Warmer Drawer before adding the food or bread dough.
An empty drawer will preheat in approximately 15 minutes.
4. When the food or dough is ready for removal, touch the
the Warmer Drawer or Bread Proof feature OFF. The Warmer Drawer indicator
light will turn OFF.
Warmer Drawer Food
Temperature Settings
Use the recommended Warmer Drawer
food temperature settings table (See Fig.
6). If a particular food is not listed, start
with the MED setting. If more crispness is
desired, remove the lid or aluminum foil
from the food.
Most foods can be kept at serving
temperatures on the MED setting. When a
combination of foods are to be kept warm
(for instance, a meat with 2 vegetables and
rolls), use the HI setting. To avoid heat
loss, do not open the Warmer Drawer
repeatedly while in use.
once to turn ON the power level for
to turn ON the power level for LO (Fig. 4). The Warmer
or
pads will decrease or increase through
Warmer Drawer Recommended
Food Item
Bacon
Hamburger Patties
Poultry
Pork Chops
Fried Foods
Pizza
Gravies
Casseroles
Eggs
Roasts (Beef, Pork, Lamb)
Vegetables
Biscuits
Rolls, hard
Pastries
Rolls (soft)
Empty Dinner Plates
pad at least once. Note: For
pad once to turn
Food Settings Table
Setting
HI
HI
HI
HI
HI
HI
MED
MED
MED
MED
MED
MED
MED
MED
LO
LO
Fig. 6
14
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5

Publicité

Chapitres

Table des Matières
loading

Table des Matières