Publicité
Les langues disponibles
Les langues disponibles
Menu 10 – settings by installer
4.6.9
This selection is reserved exclusively for the authorised COLA service centre technician.
4.6.10 Menu 11 – ECO mode
The selection ON in the ECO mode limits the stove to operate in modulation, i.e. at minimum power and minimum
ventilation. The display shows NIGHT ECO and the corresponding symbol lights up.
4.7 Remote control
The remote control is a device that transmits through an infrared diode. Therefore it must be pointed towards the
receiver unit fitted in the control panel.The remote control allows the following operations:
P1 and P3: Buttons to set the power
level
P5: Button for accessing the MENU
P7: Button to activate/deactivate
ECO mode
P9: On/Off button and for exiting the
MENU
4.7.1 Replacing the battery
The remote control is powered by a 3-volt CR2025 type battery located in the bottom of the device. For its insertion
and possible replacement, proceed as follows:
- Operate the lever indicated;
- Pull out the battery tray and replace the battery ( 3-volt CR2025 model ) respecting the polarity;
- Insert the tray;
- Check proper functioning.
- Keep the remote control away from direct heat sources and water.
-The remote control battery must be replaced and disposed of safely in compliance
with local regulations.
4.8
Installation procedure
The stove installation procedure depends on the type of water system it is connected to. It can also differ
depending on the use of an external thermostat or the internal probe.
For the correct electrical and water connections, contact a specialised technician.
4.9
Idle period (end of season)
If the stove is not used for long periods, and/or at the end of each season, it is advisable to proceed as follows
- remove all the pellets from the hopper;
- disconnect the power and remove the power cable;
- clean thoroughly and, if necessary, have any damaged parts replaced by qualified personnel;
- protect the stove from dust with suitable covering;
- store in a dry and safe place protected from atmospheric agents.
P2 and P4: Buttons for setting the
temperature
P6: Button to exit the MENU
P8: Button to activate/deactivate
STANDBY mode
P10: Button to activate/deactivate
the CHRONO function
44
battery tray
lever
PETIT
Publicité
